Posts by CussyG

    Hello everybody,


    I've been enjoying playing my G3 for a couple of months now. While switching on the amp the other day the fuse blew. I replaced the fuse, tried again and it blew again. So I decided to investigate.


    When I disconnect the amp from the power supply and measure the power supply output voltages everything seems to be fine (same as measured in January this year...see attached measurements. But when I connect the amp to the power supply again is where things get strange, I get no voltage readings, even at the power supply output?


    Does anybody have any advice here.


    Thank you in advance and regards

    Hello Martin,


    thanks for the reply...and excuse this late one.


    I fiddled around a bit but could'nt trace the problem. So I ended up ordering new caps and resistors and started from scratch. The effort was all worth it...the amp sounds really good.


    Regards

    Hello everyone,


    so I just finished taking measurements on my completed G3. The voltages seem a bit high to me, but since there wasnt any noise or strange smells I plugged in my guitar to see if it plays. Unfortunately there is no sound.


    I've attached the my measurements.


    Any advice will be greatly appreciated.


    Thanks in advance