IMPEDANCE PROBLEM (G2 KIT)

Hi.

I am going to put two output jacks to have either 8 and 4 ohms (maybe 16 ohms I do not know yet). The problem is that I do not know which is the common ludge in the output transformer. Which is the ludge I have to use for the common negative pin?

Thanks a lot!!

Re: IMPEDANCE PROBLEM (G2 KIT)

Hi,

So if I want to put two jacks, one with 8 and the other with 4 ohms, and the primary impedance is more or less the same (in both cases) using the pins 5 - 3 for 8 ohms and 1 - 3 for 4 ohms, it means that I can change the pin grounded (pin 5) to pin 3 and this pin will be the common pin for the two outputs?

Thanks

Re: IMPEDANCE PROBLEM (G2 KIT)

Ok, thanks a lot!!

Now, another question. If I want to put three outputs, one for 8 ohm, another for 16 ohm, and another one for 4 ohm and the primary impedance is more or less the same using the pins 5-3 (for 8 ohm), the pins 1-3 (for 4 ohm) and the pins 2-5 (for 16 ohm): What can I do?, because there is no common pin for the three outputs, so...
Which it is the solution?

Thanks again