The "b" since I went out on a limb and did an alternative version to fit my needs better.
Probably screwed it all up bad. 
A terminal strip version with a rotary fat/smooth switch.
I've checked it against the schematic and it should work.
I'll get back with some measurement numbers tomorrow but they were all pretty off. The heaters were around 3V if I remember correctly for instance.
It does pass signal though it's not that loud and the high end is rolled off. More imporantly there's a really strong weird noise when the tone pot is at zero. Perhaps some kind of oscillation from cables being tied together?
I really don't know where to start since it is a bit from the original design, any ideas?
I've got a pdf drawing of my version but I guess you don't want that up?
Perhaps it's ok since there isn't any values written out.
Let me know if I should take it down and it's done instantly.
Thanks!