j5mk1-heaters wiring

racek

Hi, i am doing the j5mk1 and i have a question!

I don't know how the heather wires (red-white) exactly go?
is a bit understandable in the layout where all the wires cross themself..
so if i see right it goes like that:
from the power suply board goes one red and one white wire directly to the V1? first is going to pin 4 and 5 , and the second is going to pin 9? am i right?
then the V2 and V3 are wired together ? two wires from V2 ( pin 4 . 5) are going to V3 (to pin 4)
and two wires also from V2 ( pin 9) are going to V3 ( pin 5 ? )
is this right?

thanks!

MAD

Re: j5mk1-heaters wiring

Hi,
the colors are not relevant, you only should connect the same pins at V1 and V2. So do it just like described (and shown in the picture) on page 17 of the manual :
- red wire from the power supply board to V2, pin 9
- white wire from power supply board ro V2, pin 4 and 5
- red wire from V2, pin 9 to V3, pin 5
- white wire from V2, pin 4 and 5 to V3, pin 4
- red wire from V3, pin 5 to V1, pin 9
- white wire from V3, pin 4 to V1, pin 4 and 5

Regards,
Martin

Jetzt mitmachen!