noise when put 100% VOLUME AND GAIN M15MK1

I REBUILD MY M15MK1 when i put 100% ON CHANNELL 2 i have noise i big pschhhhhhh!
so if i move the out put wire which go to transfo out put noise moove but ican t found no noise on channel 1 AND CHANNEL 2

no body can t help me?please

i ll post picture in 5 MINUTE.
voltage are good
i have a problem with 6.5 on v1 ON THE TWO AMPS WHEN I MOVE WHITE AN RES WIRE THERE IS MORE OR LESS NOISE AND I HAVE A PROBLEM WITH THE OUT PUT AMPLIFIER WIRE V4 V5 i have more or less noise 50 100 hz when i move it i test with shielded wire on picture but no change alwais noise on channel 1 AND TWO
THE CIRCUIT BOARD WHERE IS A LOT OF COMPOSANT IS GOOD SOLDERED
AND SOCKET TUBE ARE GOOD SOLDERED
MAYBE I MUST REMAKE POWER CIRCUIT BOARD,?? I TEST TRANFOS TUBE ARE GOOD I DON T FOUND SOLUTION
THANK MAD FOR YOUR ATTENTION

http://img156.imageshack.us/g/pict0732.jpg/

THIS A LOT OF PICTURE
http://img156.imageshack.us/g/pict0732.jpg/