Hi, I really need help. I'm confused :confused: about the part where the use for the A15 is handled. It says: Remove the existing 20v windings from the PT (lugs 11-12). Well, I looked over and over again but in my case the 20v windings (red/green) are on lugs 13/15 of the PT ???. If this is correct, do I then have to connect them both to the PCB (green and upper red wire at CN1) ? And the Bias (lower red wire at CN1) goes from there to the Amps power board? Does that mean that the green wire to the power board isn't reconnected again? As an amateur (used to do a little in transistor circuits though...) I'm not looking through at all. Could do with some professional help.
Cheers,
Rainer
(Outsider)